RaspberryPi RC car controlled through the WEB

This is my first raspberry pi controlled RC car using Webiopi. Have a look at the basic steps that I’ve gone through to make this car.

Materials used:-
-DC moto stepper (buy one from ebay)
-Raspberry pi with Webiopi installed  (tutorial to install webiopi)
-rc car [get one from your stores]
-GPIO cables and wires
-AA batteries for car

Motor relays pins explained:-
-the pins on the sides on the board is for the wires(+/-) of the motors
-the three pins are (+ve from battery of car, Ground of battery of car + Ground of RaspberryPi, 5V from raspberryPi)
-the remaining 4 pins [each pin control the motor (forward/backward and forward/backward)] and
remember to put the same pin into the GPIO pins on the raspberry pi.

A few pictures about the rc cars and the wires used:-



When everything is hooked up, power on the raspberry pi and login into the default webiopi homepage

https://ip.com:8000 using default username and password

Controlled each pins on the web ;)

I have followed this guy from YouTube for a more detailed overview of the configuration and settings
here

More tweets to come 😀